Replacement Master Lock Key For Trailer Hitch Lock

Question

Question:

My husband has lost the only key he had to his trailer hitch lock. It’s a Master no. 36 is there any way to get a replacement key for this particular lock?

asked by: Teresa P

0

Expert Reply:

We do have a replacement key for your MasterLock trailer hitch lock. The Replacement Key for MasterLock Coupler Locks # MLK1 is a universal replacement key, all you need to do is type your key number into the "Key Number" box, and a replacement will be sent to you.

expert reply by: Bryce D

0

Key Number Box
(click to enlarge)

Answer 1

The Master Lock Hitch Receiver and Coupler Latch Lock Set - Padlock - 1-1/4" and 2" Hitches #2848DAT has replacement keys if you know the key number using #MLK1. If you do not know your key number, unfortunately there is no way to determine…

view full answer...

Answer 2

To determine the size of the receiver lock you will need you need to determine the size (see link below) of the receiver on your vehicle and you also need to measure the overall width of the outside of the receiver at the hitch pin hole. If you have…

view full answer...

Answer 3

Without knowing what brand of lock you have, I was able to find that MasterLock has a key that has that number. For your replacement key, you will want to use part #MLK1. You will enter the key number in the box and then select the quantity of…

view full answer...

Answer 4

Yes, we do offer replacement keys for MasterLock Trailer Coupler Locks. In order to obtain this you'd simply need the Replacement Key for MasterLock Coupler Locks part #MLK1. There is a spot on that page where you will be prompted to enter your…

view full answer...

Answer 5

I went out to the warehouse and looked at some of our Master Lock Laminated Steel Padlocks #ML1KA which look like the one in your picture. None of them had a lock number stamped on them like the one in your picture does. If you are needing a key for…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Replacement Master Lock Key For Trailer Hitch Lock

Product Page this Question was Asked From

Continue Researching