Quickest Removal/Reinstall Retractable Tonneau Cover For A 2019 Ford F-250 Super Duty 6-3/4' Bed

Question

Question:

Could you tell me which of retractable tonneau covers are the easiest to remove for full bed access?

asked by: Martin V

0

Expert Reply:

The Pace Edwards Switchblade Retractable Hard Tonneau Cover - Aluminum and Vinyl - Black # PE46QJ is going to be the quickest removal for you. After the initial installation, the tonneau cover can be completely removed or reinstalled in approximately 10 minutes. The Switchblade is great for whenever you need to haul large items that require full bed capacity from front to back and side to side. After your large haul is complete, you can easily reinstall the cover to protect your truck bed again.

To utilize your entire truck bed, detach the canister from the side rails by removing the bolts on either side with a wrench. Then take the side rails off your truck by removing the clamps with the same wrench. Wrap the pull-strap around the canister and use it to lift the canister off your vehicle.

expert reply by: Kevin C

0

Answer 1

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with…

view full answer...

Answer 2

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 3

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

From your question it sounds to me like someone has cut off the tow package plug on your 2005 Ford F-150 and wired in a 4-way connector. In this case you could use the Hopkins Adapter 4-Pole to 7-Pole and 4-Pole, #37185 which will give you a 4-way…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Your 265/70R17 size tire is around 31-1/2 inches in diameter. You want to make sure the tire cover you get is large enough and doesn't have to be stretched over the tire. I'd rather have one that's slightly loose than one that tears…

view full answer...

Answer 9

Hey Chad, so I'd actually recommend a mid size ladder rack like the Yakima OutPost HD Overland Truck Bed Rack #Y01152-58. This is by far going to be your best bet if you don't want to trailer your kayaks. These bars have a 500 lb weight…

view full answer...

Answer 10

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 11

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Quickest Removal/Reinstall Retractable Tonneau Cover For A 2019 Ford F-250 Super Duty 6-3/4' Bed

Product Page this Question was Asked From

Continue Researching