Best Suspension Enhancement System for a 2021 Toyota Tundra For a Self-Install

Question

Question:

I am needing a suspension enhancement system for my 2021 Toyota Tundra. I want something that I can install myself if possible.

asked by: Cindy

0

Expert Reply:

I have a great suspension enhancement system that you can install on your 2021 Toyota Tundra. The RoadActive Suspension Custom Leaf Spring Enhancement Kit # RAS34FR is going to be a great option to improve your vehicle's stability, handling, and control while you are towing or hauling, as well as when your vehicle is unloaded.

This custom-fit kit comes fully assembled and is easy to install. Each RAS unit simply bolts onto your factory leaf spring with the included hardware, and drilling, welding, and cutting aren't required. First, position the eye hook bracket so that it wraps around the top of the factory leaf spring eye. Then the axle bracket secures under the leaf spring and around the factory U-bolts on the other side of the leaf spring pack.

expert reply by: Scott S

0

Answer 1

The RoadActive Suspension system #RAS34FR effects the suspension, so it will work with any body lift that you may have in place. The RAS system will lift the rear of the vehicle approximately 1" to 1-3/4" depending on the truck, so the bed…

view full answer...

Answer 2

That's a good question. I have seen videos of this product installed and many times the (part C) eye bracket hook just lays onto the leaf spring eye. However, since 2008 the Tundra's have required one side of the eye hook to be removed. I…

view full answer...

Answer 3

Since you haul pretty often on your 2021 Toyota Tundra, a great overall suspension option is the RoadActive Suspension Custom Leaf Spring Enhancement Kit #RAS34FR. Not only will this enhancement kit prolong the general life on your factory springs,…

view full answer...

Answer 4

For your 2010 Toyota Tundra 2WD with a Snug Top Camper Shel towing a 34' Travel Trailer with 800lbs tongue weight and 8000lb trailer weight using a weight distribution hitch I recommend the RoadActive Suspension Heavy Duty #RAS34FR with a 3000lb…

view full answer...

Answer 5

We do not have any set screws for curtain rods, however we do have the Snap-In RV Curtain Carriers #37281455 which you could use instead to secure and adjust your curtains. This kit contains 14 carrier and easily installs onto some snap tape like the…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 10

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Best Suspension Enhancement System for a 2021 Toyota Tundra For a Self-Install

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching