Can ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 Attach to Plastic Tank

Question

Question:

just wondering if one of these pads can be attached to a hydralic leveling tank plastic to warm the hydralic fluid for leveling pads .

asked by: Eric

1

Helpful Expert Reply:

Yes you could attach the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 to a plastic tank for hydraulic fluid to keep it warmer.

expert reply by: Jameson C

1

Answer 1

A device like the ThermaHeat RV Holding Tank Heater Pad #277-000164 will function for as long as your battery has power, but this time period can vary quite a bit depending on the battery capacity and condition. Since this item also has a thermostat…

view full answer...

Answer 2

According to page 328 of the online version of the owner's manual for your 2019 Buick Enclave you will need to do the following before towing your vehicle with a tow dolly (it states that your Enclave cannot be flat towed): 1. Put the vehicle…

view full answer...

Answer 3

I reached out to my contact at LaSalle Bristol regarding their ThermaHeat RV Holding Tank Heater Pads like #277-000164, and she did say that the pads should be applied to the bottom of the tank and should not be subjected to any kind of pressure or…

view full answer...

Answer 4

The Holding Tank Heater Pad #277-000164 does include instructions. They're actually on the label that is stuck to the pad itself. It can be wired to DC power while your traveling and through a converter when you're connected to a power…

view full answer...

Answer 5

It sounds like you have a heating pad like the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat #277-000164. I reached out to my contact at Lasalle Bristol and they recommend using 3M Hi Strength 90 spray adhesive to reattach the pad to…

view full answer...

Answer 6

The ThermaHeat RV Dump Valve Pipe and Elbow Heating Pad #277-000162 pulls 0.3 amps and the ThermaHeat RV Holding Tank or Step Heater Pad #277-000164 pulls 4.8 amps. Assuming that you're having them all run off the same switch and wiring you would…

view full answer...

Answer 7

You can apply the ThermaHeat RV Holding Tank or Step Heater Pad with Thermostat #277-000164 to the side of your tank if you like, it certainly won't harm anything, assuming it is not touching any conductive surfaces. The reason they are supposed…

view full answer...

Answer 8

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 9

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Can ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 Attach to Plastic Tank

Product Page this Question was Asked From

Continue Researching