Will the Brophy Camper Hold Downs # HSBP Fit a 2009 Chevy Silverado

Question

Question:

Will these Brophy Truck Bed Accessories - HSBP Camper Hold Downs with Zinc Coated Finish fit a 2009 chev Long bed Extended Cab?

asked by: Edward E

0

Expert Reply:

The Brophy camper tie downs # HSBP are made to fit newer domestic full size trucks like your 2009 Chevy Silverado. It will NOT fit the following:

Will not fit step side beds or some double-wall beds
Will not fit some Dually beds
Will not fit some import trucks
Will not fit 2004-2008 Ford F-150 Pickups

Even though there is no specific truck fit list, provided that your Silverado is not a step side bed, double wall bed, or a dually it will fit.

expert reply by: Michael H

0

Answer 1

It is very likely, but you'll need to measure the bed rails of your 2017 Ford F-250 in order to ensure the fit of the Brophy Clamp On Camper Tie-Downs #HSBP. The reason for that is, these are a universal-fit application and not vehicle-specific.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 11

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 12

Both Firestone Ride-Rite kits are good options for your 2024 Ford F-250 Super Duty 4WD, but I like to recommend the 7,500 lb #F95FV rating over the 5,000 lb Rating #F35FV simply because it means the air bags can be used for the same application but…

view full answer...

Will the Brophy Camper Hold Downs # HSBP Fit a 2009 Chevy Silverado

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching