Will the Lippert Power Stance Electric Trailer Jack Work with 4" Mounting Pattern
Question:
My triangle bolt holes are at 4 in centers, are they the same on lc89vr
asked by: Ciaran G
Helpful Expert Reply:
The industry standard a-frame trailer tongue jack mounting pattern is 3" on center. The jacks we offer for this standard like the Lippert Power Stance Electric Trailer Jack part # LC89VR have slotted mounting holes so they will work even if the dimensions are slightly askew but you may have to enlarge the holes slightly if they don't quite match up. This would be the case for nearly all jacks since they use the same industry standard mounting pattern.
Product Page this Question was Asked From
Lippert Power Stance Electric Trailer Jack w/ 7-Way Plug - A-Frame - 18" Lift - 3,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Continue Researching
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Q&A: Can The Lippert TT Leveling System Be Installed On A 2023 Lance 2285 Travel Trailer?
- Q&A: Bent Lower Leg Replacement on Lippert Ground Control Tongue Jack
- Q&A: What Weight Capacity of Tongue Jack is Needed for a 4,600 Pound Dry Weight Trailer
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Q&A: How to Wire the Lippert 421366 Replacement Tongue Jack for Use Without Lippert Ground Control System
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Big Truck Big RV
- Article: Best Camper Jacks
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Rooftop Cargo Carriers