Dimensions of the Box for the Superwinch Winch 2 Go Portable Winch  

The Superwinch Winch 2 Go Portable Winch #SW1140232 would need to be bolted down to your enclosed snowmobile trailer in order to attach. I added a photo of the winch which shows the underside of the winch and the mounting holes. They are spaced…

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

While we do have a variety of winch mounting options, I can't say for certain that any of them are a specific replacement for your Aluma Series 82 car trailer. With that being said, we do have a universal winch mounting plate as part…

The Superwinch Winch 2 Go 4000 SR, part #SW1140232, is designed fto operate with power input from the batteries typically found in lawn tractors, ATVs, UTVs or motorcycles. Naturally, the higher the battery capacity the more running time. According…

Yes, the Superwinch Winch 2 Go 4000SR part #SW1140232 will hold while you are making the steering adjustments on the vehicle. It has a 4,000 lb line pull capacity but please keep in mind that the vehicle, assuming the wheels turn freely is considered…

The LT3000 winch, #SW1130220, is a good choice for pulling a 2,350 pound vehicle onto your trailer. With a rolling load (your vehicle) on a 17 degree slope (typical range for a trailer ramp) the winch will have a 7,825 pound rolling load capacity.…

For a 12,000 lb. electric car trailer winch like the Bulldog Winch Trailer Winch part #BDW10040, I recommend a standard 12 volt lead acid battery rated up to at least 650 cold cranking amps (CCA). As long as the battery is rated up to 650 CCA then…

We only carry the Dexter Electric Trailer Brake Assemblies Left #DX25QR and Right #DX52QR for your Dexter axle. We do not carry the replacement lever, magnet or hardware separately for these brake assemblies.

The holes on the mounting plate for the Bulldog Winch #BDW15019 are spaced 3-1/8 inches x 4 inches center on center. The winch mounts to the plate in holes that are 6-5/8 inches x 3 inches apart center on center. I have attached a photo showing these…