How to Tell If Curt Adjustable Width Trailer Hitch Will Fit a 2018 Rockwood UltraLite 2604
Question:
The trailer has Lippert PS-1 stabilizer installed on a welded bracket from the factory. Do you know if the 2 1/4inch flange on the13703 bracket will clear the factory welded stabilizer bracket? Also, since the 13703 bracket is not bolting to the I-Beam lower flange, does it matter if I raise and bolt it against the inside of the I-Beam to gain ground clearance?
asked by: Jim A
Expert Reply:
I wish I had a straightforward yes or no answer to your question, but to be perfectly honest this is a universal hitch and we haven't tested it out for different mounting scenarios. The one thing I can say is that the mounting brackets that come with the Curt Hitch # 13703 can be mounted so that they are facing in towards the middle of the camper or out towards the sides of the camper depending on what your situation calls for with the stabilizer like part # LC369774 installed.
Hopefully between this and the attached dimensional photo you'll be able to get a good feel for whether or not this hitch will work for your application. The photo also shows the different ways that the bracket can be used which should be able to tell you if you can install it on your I-Beam in the way that you are asking.
Attached is an installation video of this hitch on a 2017 Rockwood Mini Lite to give you an idea of the steps you'll be taking for the install.
Products Referenced in This Question
Lippert High-Speed Power Stabilizer Jack - White Switch Kit - 30" Lift
- Camper Jacks
- Fifth Wheel Camper
- RV Motorhome
- Travel Trailer
- Leveling Jacks
- Stabilizer Jacks
- Steel
- Electric Jack
- 30 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 22 - 72 Inch Wide Frame
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Trailer Wiring Diagrams
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Replace or Install an RV Roof Vent