What Would Cause Prodigy P3 Brake Controller to Only Show 2.9 Volts When Brakes are Applied
Question:
just installed the 90195 had to use the trailer and the gain was only putting out 2.9 when pushing the brake while towing i tried the boost levels it helped a little so i set the gain to 14 and still only putting 2.9 and i can smell my brakes cooking the manual lever works when i tried that i put my old controller back in to try and that works no problem am i missing something maybe a setting somewhere
asked by: Scott
Expert Reply:
Sounds like maybe the P3 part # 90195 isn't orientated properly for the inertia sensor to work like it needs to. The controller needs to be facing the rear of the tow vehicle squarely and also be level from side to side like what you see in the picture I attached.
It could be you have a short between the 12 volt and the brake output circuit too so I'd check there to be sure there isn't a short between these two circuits.
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: How Does Brake Controller Install on Freightliner S2RV Chassis
- Q&A: Suspension Enhancement Recommendation for 2019 Toyota RAV4
- Q&A: Parts Needed to Add 7-Way & Brake Controller on 2023 Kia Sportage
- Q&A: Replacement Lid and Lift Arm for Dometic 810263