Tekonsha Voyager Light Not On When Leveling
Question:
I just installed a this 9030 voyager brake controller, and went to level it out per the instructions. When I set the gain to max, depress the brake pedal, and then slowly move the delay forward, I don’t get a change in the light color. It stays green the whole time. Brakes seem to be engaging. There is voltage in the red wire. The red light comes on when I slide the manual slide all the way. Do you have any suggestions
asked by: Eli F
0
Products Referenced in This Question
Digital Multimeter with 42" Long Test Leads - LED Display
- Electrical Tools
- Testers
- Multimeter
- Yellow
- Performance Tool
more information >
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Best Camper Jacks
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)