Are Mounting Parts Included with RoadMaster Quick Disconnects RM-222
Question:
does these parts come with the flat plates, bolts, nuts and washer required to mount them?
asked by: keny w
0
Expert Reply:
Yes, the flat plates, bolts, nuts and washers for mounting are included with the Quick Disconnects part # RM-222. I spoke with my contact at RoadMaster, and they confirmed that the following hardware is included:
Pair of carside quick disconnects
Pair of backing plates
4 1/2 inch bolts
4 1/2 inch lockwashers
4 1/2 inch washers
4 1/2 inch nuts
2 lynch pins
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Replacement Roadmaster Tow Bar Quick Disconnect Brackets - Car Side Only
- Accessories and Parts
- Tow Bar
- Quick Disconnects
- Car Side
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Replacement For A Dometic DOTR12CB RV Microwave
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Protective Case for NOCO Boost X Jump Starter
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Tire Sizing
- Q&A: Blue Ox Parts Needed to Flat Tow 2022 Jeep Gladiator Rubicon
- Article: Trailer Wiring Diagrams
- Q&A: Wiring Required For Towing a 2007 Hummer H3 Behind a RV Motorhome
- Article: How to Store a Travel Trailer/Camper for the Winter
- Q&A: Roadmaster Base Plate Kit that Fits 2023 Jeep Wrangler and Stowmaster Tow Bar
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: How to Flat Tow a 2005 Dodge Dakota Behind a Motorhome with a Roadmaster Nighthawk Tow Bar
- Q&A: Dimensions for Roadmaster Replacement Swivel Collar for Falcon 2 Tow Bar # RM-9200-4