How To Turn Off The VueSMART Trailer Backup Camera LEDs

Question

Question:

In the state of Pennsylvania, the led lights activate as soon as the trailer lights are energized thus making illegal.

asked by: Mike M

0

Expert Reply:

If you need the light to be off when your driving, you can turn off the LED on the VueSMART RV and Trailer Backup Camera # HM34FR on the app. I've inlcuded a video that you can watch to see how Rob did it. It's at 7:30 in the video. He will show you the little button on the bottom of the app that'll turn off the LED so you can drive legally.

expert reply by: Adam E

0

Answer 1

The VueSMART RV and Trailer Backup Camera #HM34FR that you referenced is designed to display onto a smart phone as a monitor.

view full answer...

Answer 2

That's a really good question and we have actually asked Hopkins about the ability to sync from mobile devices to the stereo screens when using the VueSMART RV and Trailer Backup Camera #HM34FR. What they told us is that it is very likely it will…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 9

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 10

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

How To Turn Off The VueSMART Trailer Backup Camera LEDs

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching