What is Amperage Draw of Electric Jack part # EJ-3520-BBX
Question:
HELLO, i PLAN ON USING A MODEL# EJ-3520-BBX JACK AS AN ASSEMBLY LINE VERTICAL TABLE LIFT WITH MAX LOAD OF 200LBS PAYLOAD HOW MANY AMPS AT 12VDC SHOULD I EXPECT THIS UNIT TO DRAWER. WE WILL BE USING AN CONVERTER TO POWER THE JACK FROM 110V AC. THANKS,
asked by: JOE E
1
Helpful Expert Reply:
The Electric Jack part # EJ-3520-BBX will pull up to 30 amps before it would blow it's fuse so you'd need a power source capable of providing at least 30 amps.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Article: Best Camper Jacks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Q&A: Replacement Margay Wheel in Gunmetal Gray for ALCOM Stealth Car Hauler
- Q&A: Electric Trailer Jack Recommendation for a 7,500 lb Boat Trailer
- Q&A: Venture Bevel Gear Kit Instructions
- Q&A: What Size Tires Fit 15x6 Inch Steel Trailer Wheels
- Q&A: All Parts Needed to Flat Tow 2023 Cadillac Escalade With Blue Ox Tow Bar
- Q&A: Can the MORyde Safe-T-Rail be Installed On a Class A Motorhome