Recommended Replacement Tongue Jack For Additional Ground Clearance On Angle Iron Trailer Frame
Question:
I had a strange incident towing my small homemade camping trailer. The jack hit a rail on a cattle guard and broke the hitch pin, causing the trailer to come loose and drag on the jack, bending it. Thankfully the chains held and that someone stopped who happened to have an extra pin. I thought to change the jack to a fold away so I have more clearance. My trailer frame is an L shaped angle iron. Will a bolt on one work? I really dont want something that needs welding. The trailer is lightweight, only 4x4foot box.
asked by: Michelle
Expert Reply:
For the etrailer Round, Snap-Ring Swivel Jack #TJBB-2001-B to fit properly on your homemade camping trailer the frame will need to be boxed. This would require having additional frame material welded where you intend to mount the new jack.
I recommend installing the Ultimate Trailer Jack # 322-RDJ-2K in your A-frame mount. This jack assembly can be raised to 1-3/4" with the jack retracted and moved to its lowest setting. The jack can then be adjusted in 2" increments up to 12" and raised up to an additional 15-1/2" with the crank handle.
Products Referenced in This Question
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Product Page this Question was Asked From
Round Snap Ring Swivel Jack w/ Footplate - Bolt On - Black - Topwind - 10-1/2" Travel - 2K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: What is the Distance from the Pipe Mount to the Bottom of the Leg on the Trailer Valet JXS Jack?
- Q&A: Replacing A Lippert A-Frame Jack For A Side-Mount Swivel Tongue Jack
- Q&A: Does the Galeo Ride GPS Tracking Device for Bikes Come with Everything Needed
- Article: How to Measure a Trailer Axle
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Can 4.80-12 Tires Be Upgraded to 5.30-12 Tires
- Q&A: How to Determine if Scissor Jack Will Fit Camper
- Q&A: What Mounting Bracket Is Needed for the Round Snap Ring Swivel Jack TJB-2001-Z
- Article: Trailer Jacks
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: Determining Trailer Tongue Weight
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub