Difference Between Valterra T1003-7VP and T1003-9VP Replacement RV Waste Valve Seal/Hardware Kits
Question:
what is the difference between the 7VP and the 9VP seal kits. which would work for my 3 inch valves? are they interchangable. I dont know which to get
asked by: Darryl C
0
Expert Reply:
For a 3 inch waste valve, you'd want to use the Valterra # T1003-7VP kit. The # T1002-7VP kit is for 2 inch valves, and wouldn't work with your 3 inch valve.
expert reply by:
Mike L
0
Products Referenced in This Question
Replacement Seals and Hardware for 3" Valterra Waste Valves
- Accessories and Parts
- RV Waste Valves
- Waste Valve Parts
- Seals
- Valterra
more information >
Product Page this Question was Asked From
Replacement Seals and Hardware for 3" Bladex Waste Valves
- Accessories and Parts
- RV Waste Valves
- Waste Valve Parts
- Seals
- Valterra
more information >
Continue Researching
- Shop: Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear
- Shop: Replacement Crank Handle for Lippert Manual Scissor Jack
- Shop: Replacement Drive Head Motor Gear Pack for Solera Power RV Awnings
- Shop: Replacement RV Air Conditioner Cover for Dometic Brisk Air II - White
- Q&A: Replacement Lens Needed for Light with SAE-P2-A98 On Lens
- Q&A: Valterra Waste Valve Seal Kit for Old Style Valves
- Shop: Voyager Rear Camera with LED Low Light Assist - Black
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 89" Long - 5,200 lbs
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 86-1/2" Long - 5,200 lbs
- Search Results: 5200 lbs axle
- Shop: Windshield Wiper Blades
- Video: Lippert Offset Cable Spare Tire Winch Review
- Search Results: dexter axle 5200
- Search Results: sae p2 a 98 dot
- Search Results: 45937
- Search Results: 36398
- Q&A: Correct Replacement for Magnetek Converter 6350
- Search Results: 733513
- Search Results: lc404523
- Q&A: Replacement 5973820 Motor for Kwikee RV Steps
- Q&A: Understanding Difference Between Hubs and Spigots for RV Waste Valves
- Q&A: Replacement Seals and Hardware for 3" Valterra Waste Valves
- Q&A: Correct Replacement Seals For Valterra Bladex 3 Inch Waste Valve
- Video: TruRyde Bearing Kit for #84 Spindle Installation
- Shop: Fifth Wheel Hitch
- Shop: Base Plate for Tow Bar
Chris S.
5/21/2024
Mike, Your answer to the question, "What's the difference between the Valterra T1003-7VP and the T1003-9VP Replacement RV Waste Valve Seal/Hardware Kits" does not seem to address the correct question. There's no mention about the 2" seal. The parts listed are both 3" seals, but we're not sure wish is best to put in a Valterra T1003PBC 3" Valve Body. Thanks for your time. Chris