Parts Needed to Install Draw Tite I-Command Brake Controller in 2005 Ford Explorer
Question:
I just purchased the 5535 controller with 3035-P. What else would I need to wire a 2005 ford explorer? I believe there is a connector for the controller.
asked by: Jack N
0
Products Referenced in This Question
Tekonsha BRAKE-EVN Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Up to 4 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: Trailer Wiring Diagrams
- Q&A: Damaged Caused to Travel Trailer Brake Drums and Bearings by High Temperatures
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Article: How Long Can You Boondock in an RV?
- Article: Trailer Tire Sizing
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Hanger Spacing Dimensions for Installing Double-Eye Leaf Springs on a Trailer
- Article: Replacement Automotive Lighting
- Q&A: How to Measure Hub Face of Mobile Home Hub and Drum
- Article: Gooseneck Trailer Hitch Information and Review
- Article: How to Install E-Track in 3 Easy Steps