How Much Does the Stromberg Carlson Trailer Tray Cargo Carrier and Replacement Tray Weigh

Question

Question:

What is the weight of the Stromberg Carlson replacement tray?

asked by: George M

0

Expert Reply:

The Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers part # CC-255 weighs around 60 lbs and the Replacement Tray for Stromberg Carlson Trailer Tray Cargo Carrier part # 7605-101P weighs around 20 lbs.

expert reply by: Conner L

0

Answer 1

I have attached a picture with the dimensions drawn inside for the Replacement Tray for Stromberg Carlson Trailer Tray Cargo Carrier item #7605-101P. It weighs 18 lbs and has a 300 lbs capacity.

view full answer...

Answer 2

Easiest way to lock a generator to the Stromberg Bunk carrier part #CC-255 would be to run a cable lock like the part #8218DPS around the base of the bunk and then through the handles of the generator.

view full answer...

Answer 3

The Stromberg Bunk Adapter part #CC-255 is a great solution for what you are looking for. This attaches to the frame members of your camper and gives you a platform up above the propane tanks to carry a generator. I attached a picture of this…

view full answer...

Answer 4

There's quite a bit of available room under the bunk adapter #CC-255 to allow you access to the propane tanks. I attached a couple pictures that shows how much room you'd have. I also attached a review video link for more info on it…

view full answer...

Answer 5

If you can't place any weight on the trailer in any way that limits a lot of the options. Basically you'd have to decide if you could fit in in the interior or use a bunk like part #CC-255 as a platform on the tongue of the trailer.…

view full answer...

Answer 6

I looked up pictures of the coupler on the front of your 2013 17ft. Casita Liberty Deluxe Travel Trailer and it looks a little bit cramped with the propane tank cover but the #CC-255 has a pretty wide range of adjustability so it should fit just…

view full answer...

Answer 7

The Stromberg Carlson Trailer Tray Cargo Carrier #CC-255 will fit on A-frames as narrow as 12 inches to as wide as 52 inches. That is measured from the outside of one side of the frame to the outside of the other side. The frame can be 3-1/2 to…

view full answer...

Answer 8

As long as you have the generator secured on the Stromberg Carlson Trailer Tray Cargo Carrier, part #CC-255, you can run the generator while it is mounted on the carrier. I recommend using s-hook ratchet straps like part #SM54FR. These are 1-inch…

view full answer...

Answer 9

The Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers part #CC-255 is not going to provide the best ground for your generator. However, we do not carry Champion Generators therefore I strongly urge you to call the manufacturer to see…

view full answer...

Answer 10

Adding the Stromberg Carlson Trailer Tray Cargo Carrier Item #CC-255 with your generator will add tongue weight to the front of the trailer. However; if you are using weight distribution, 100lbs, may not make that big of a difference. What I suggest…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

How Much Does the Stromberg Carlson Trailer Tray Cargo Carrier and Replacement Tray Weigh

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching