Is Yakima BackSwing Swing Away Hitch Extender # Y02483 compatible Swagman Traveler XC2 # S64663

Question

Question:

The Swagman Traveler XC2 Bike Rack for 2 Bikes - 2inch Hitches or RV Bumpers - Frame Mount should be compatible with this, right? It has a 2 inch shank.

asked by: Douglas O

1

Helpful Expert Reply:

Yes, the Swagman Traveler XC2 Bike Rack for 2 Bikes - 2" Hitches or RV Bumpers - Frame Mount # S64663 will be compatible with the Yakima BackSwing Swing Away Hitch Extender for Bike Racks - 2" Hitches # Y02483.

One thing to remember, The Yakima BackSwing Swing Away Hitch Extender will work great on your 2000 Honda CR-V, and other passenger vehicles, but it is not rated for use on RVs or trailers.

expert reply by: Thomas M

1

Answer 1

The Yakima OnRamp e-bike rack part #Y36FR is travel trailer rated and when paired with a pivot adapter like the part #Y02483 you'd be set.

view full answer...

Answer 2

The Kuat Pivot #PVP20B is only rated for 2 inch bike racks because it extends the hitch point back further than your hitch receiver. 2 inch shanks are stronger than 1-1/4 inch shanks. The shank of a 1-1/4" bike rack cannot handle the added…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 9

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 10

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Is Yakima BackSwing Swing Away Hitch Extender # Y02483 compatible Swagman Traveler XC2 # S64663

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching