Troubleshooting Tekonsha Primus IQ TK90160 Having S.H Error Code
Question:
Trailer shows connected but at times, sh shows up. Could it be that the trailer and the vehicle are not grounded through the connection? Should it add a ground wire directly from the vehicle frame to the trailer frame?
asked by: Kenneth S
Helpful Expert Reply:
I would be happy to help!
The s.h error code you are getting on your Tekonsha Primus IQ # TK90160 means that it is detecting a short, and would not be caused by a bad ground. Since you mentioned this is happening when the trailer is connected I recommend starting with checking the vehicle and trailer connectors for any corrosion or debris that can cause a short.
If those check out you will want to check the brake output wire going from the trailer connector to each brake magnet on the trailer for any damage or sections where it could be getting pinched causing a short.
You will be want to be very through in checking the wires for damage, and replace any damaged sections with # 10-1-1 and heat shrink butt connectors # DW05745-5.
I included videos of the products mentioned for you to take a look at.
![Samuel C](https://images.etrailer.com/static/images/catg/people/2240_tn.jpg)
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Product Page this Question was Asked From
Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed to Install Brake Controller on 2012 Chrysler Town and Country
- Q&A: How To Install a Brake Controller On a Dump Truck
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Article: What is Boondocking
- Q&A: How to Seal Rear of RV Tail Light 30-92-001 When Installing on Uneven Trailer Surface
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps