What Crossbars do You Recommend for the Thule Force XT XXL Box on a 2017 Toyota Sienna?

Question

Question:

Thanks for the info! Would the cargo box work ok with factory cross bars?

asked by: AJ

0

Expert Reply:

The Thule Force XT XXL # TH6359B will work on your factory crossbars as long as the crossbars measure between 1 and 3-1/2 inches and a width of 3/4 of an inch to 1-11/16 inches. In order to determine if the Force XT XXL will fit factory bars for your 2017 Toyota Sienna, I recommend measuring the height and width of those particular crossbars.

expert reply by: Bob C

0

Aj

7/12/2021

Thanks for the info! Would the cargo box work ok with factory cross bars?

Reply

Bob C.

7/14/2021

In order to fit the Thule Force XT XXL # TH6359B to your raised rails of your 2017 Toyota Sienna SE, I recommend the following parts: - Thule SquareBar Evo Crossbars - Steel - 53" Long - Qty 2 # TH712400 - Rapid Crossroad Feet for Thule Crossbars - Raised Railing - Qty 4 # TH450R Thus particular roof rack system has a maximum weight capacity of 165 pounds. However, I would consult with your owner's manual from Toyota to make sure that your roof can accommodate that much weight. This roof rack system will allow you to attach the Thule Force XT XXL along with cargo without interfering with your vehicle's rear hatch when the hatch is fully open. I went ahead and attached an installation video of the Thule SquareBar Evo system being installed on a 2017 Toyota Sienna.

Reply

Answer 1

As long as the crossbars you use aren't wider than the widest part of the vehicle (usually the mirrors), which could be a safety problem or even illegal in some areas, you could certainly use longer crossbars than the 58 inch crossbars.…

view full answer...

Answer 2

For a 2013 Toyota Sienna I wouldn't recommend the track system Thule roof racks like the part #THTP54 that you referenced. This is a permanent install rack that would force you to permanently modify the roof of your 2013 Toyota Sienna. Since…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the SAE A P2 DOT 14 and would be what you'd need.

view full answer...

Answer 8

A tow package for a vehicle is usually a frame mounted trailer hitch and trailer wiring on a vehicle like your 2002 Dodge Dakota. If you have those two things you could pretty easily assume you have the tow package. Or, you can take the VIN of your…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 11

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 12

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

What Crossbars do You Recommend for the Thule Force XT XXL Box on a 2017 Toyota Sienna?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching