Will Inno Shadow 16 Rooftop Cargo Box INBRA1210BK Fit 2011 Audi A3 Factory Rack

Question

Question:

Will this cargo box fit a 2011 Audi A3 Hatchback with factory roof rails/Audi ski rack? Distance between ski racks is ~ 28, distance from rear ski rack to edge of hatch is 17. Thanks,

asked by: Richard T

0

Expert Reply:

Yes the Inno roof cargo box part # INBRA1210BK will fit the factory crossbars of your 2011 Audi A3 and would have enough clearance to allow the rear hatch to open as well.

expert reply by: Jameson C

0

Answer 1

Thank you for pointing out that discrepancy. The Yakima SkyBox NX 16, part #Y95AV, does have a crossbar spread of 24" - 36". I will have this updated immediately. As for your crossbars, the distance used is the center to center. As…

view full answer...

Answer 2

Based on my research, the measurement from the front of the crossbar on a 2017 Honda CR-V to the opening of the rear hatch is 50 inches; if so then there will not be any interference and you will be able to fully open your hatch when using the Inno…

view full answer...

Answer 3

Right around the time you bought your Yakima Skybox, Yakima changed the style of the handle. The newer style that looks like a wing or a toilet flush handle, does have a replacement part. It is the Replacement SuperLatch Handle Assemblies for Yakima…

view full answer...

Answer 4

You should be able to open the box from the other side. Once you have the other side open you can then replace the handle you took to the locksmith. Unless the locksmith wasn't able to fix the issue. If you need replacement handles we carry them,…

view full answer...

Answer 5

The best bike rack that fits the factory OEM roof rack on your 2020 Toyota Highlander is the Yakima FrontLoader #Y02103 because it is a wheel-mounted bike rack that won't require you to remove your bike's wheels to carry them. Not only does…

view full answer...

Answer 6

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 12

The Malone Universal Crossbar System #MPG201 is a more economical choice but it still does a good job. The design and quality of Thule's system is why they have such a large difference in price. Whether you go with the Thule Crossroads system…

view full answer...

Will Inno Shadow 16 Rooftop Cargo Box INBRA1210BK Fit 2011 Audi A3 Factory Rack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching