Troubleshooting a Jeep That Won't Start After Flat Towing
Question:
After disconnecting, the jeep doesn’t start. I have taken out the fuses from the Invisibrake install thinking it would reset. Not sure if that makes a difference. Just keep doing it and after awhile it does start. It appears the battery is fully charged. In another thread, there was a suggestion to just push the brake real hard to start after unhooking. I haven’t tried that yet as it doesn’t make sense. I will do more experimenting tomorrow, but hope there is some known issue and response.
asked by: John U
Expert Reply:
The Roadmaster InvisiBrake Supplemental Braking System Item # RM-8700 will drain the battery while towing so the first thing to check is if the battery is reading 12.6 volts or higher. If not then your battery is the issue. The starter could also be needing to be replaced if you're not getting a crank.
I spoke with Roadmaster and their tech stated that if you have a brake relay or custom fit brake switch installed and the wiring is incorrectly installed it could be causing this issue as well. I recommend checking your wiring and insuring if you have either of these installed that they are correctly wired with no bends or knicks in the wiring.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Shop: BrakeBuddy Towed Vehicle Battery Charge Line Kit
- Video: BrakeBuddy Towed Vehicle Battery Charge Kit Review
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 4-Way Flat Connectors
- Search Results: roadmaster invisibrake
- Search Results: motorhome mud flaps
- Search Results: rock guard tow protector
- Shop: Roadmaster Tow Defender Protective Screen for Towed Vehicles
- Shop: Roadmaster Guardian Rock Guard for Towed Vehicles
- Shop: Blue Ox KarGard Protective Shield for Towed Vehicles
- Shop: Base Plate for Tow Bar
- Shop: Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Q&A: Can BrakeBuddy Charge Line Kit Install with Tow Vehicle that has Roadmaster Invisibrake
- Q&A: Do I Need The Roadmaster Stop Light Switch To Install The InvisiBrake On A 2021 Wrangler Unlimited
- Video: Roadmaster InvisiBrake Braking System Installation - 2021 Jeep Wrangler
- Q&A: Why Would Roadmaster Invisibrake Drain Vehicle Battery
- Search Results: rm~751490
- Video: Roadmaster Direct-Connect Base Plate Kit Installation - 2020 Jeep Wrangler
- Video: Roadmaster Stop Light Switch Kit Installation - 2019 Jeep Wrangler Unlimited
- Video: Roadmaster Stop Light Switch Kit Installation - 2021 Jeep Wrangler Unlimited
- Q&A: Troubleshooting Buzzing Noise Coming From RoadMaster InvisiBrake
- Q&A: Do all of the Wires of the Invisi-Brake Need to Be Wired to Install Brake Kit
- Q&A: Roadmaster InvisiBrake Battery Charging Capabilities While Flat Towing
- Q&A: Does Roadmaster Invisibrake System RM-8700 Compressor Run Continuously
- Search Results: diode wiring kit
- Video: BrakeBuddy Towed Vehicle Battery Charge Kit Installation - 2019 Jeep Grand Cherokee
- Video: Roadmaster Universal Diode Wiring Kit Installation - 2020 Jeep Wrangler
- Search Results: brush guard