How to Determine Correct Replacement Landing Gear For 5th Wheel  

The best option to replace your Atwood MPD 71125 landing gear is from Stromberg Carlson, which is going to fit in your current mounting brackets, so all you have to do is choose the weight capacity that is right for your trailer, either 5,500 or…

Since Atwood is no longer in the landing gear making business and you have an older 5th wheel trailer I recommend just replacing your entire landing gear set. This not only gives you peace of mind that everything is in good shape but it also makes…

When it comes to 5th wheel landing gear like #RVLG-8000, tongue jacks or winches, it is usually best in the long run to use an over-spec product that can handle more weight than you're going to ask it to. This tends to increase the working…

It is possible that there is a part number somewhere that would help identify the landing gear on your trailer. Sometimes there is information on the underside of the caps on the tops of the jacks so that is another place you can check if you…

Based on your picture the replacement motor you need is actually the part #LC380073. This would explain why the #LC379608 that you referenced is not fitting at all.

According to my contact at Stromberg Carlson, their #LG-179014 follower leg would indeed be an acceptable replacement for your Venture #900-40L if the 29-1/2 inch outer tube and overall heights of 33-1/2 match your existing jack. You can see these…

For your Venture landing gear set the correct follower leg you'd need is the part #LG-179014 which matches what you sent in a picture of.

I was not able to reference the part number "VMI900L" but in order to determine if the Replacement Follow Jack w/ Drop Leg part #LG-179014 is the correct replacement for you, you will need to measure the distance between the bracket stops…

To determine the correct replacement landing gear for your 5th wheel trailer, you will need to measure the mounting brackets on your trailer from the underside of the top bracket to the top of the lower bracket as shown in the diagram. From there you…

If you need to replace the slave leg in your landing gear set up then you can use Stromberg Carlson, #LG-179014, will fit. The lead leg would be #LG-179013. Each leg has a 3,000 pound capacity. These legs have many of the same parts because there is…

Sounds like the correct follower leg you would need is the #LG-179014 that you referenced. The overall length of the leg is 33-1/2 inches and the distance from the inside of the two brackets is 17-1/2 inches. Check out the picture I attached for more…

You will either need to connect to your truck or have another stabilizer to support the weight when you remove the landing gear. The lead or follow leg can then be removed by loosening the welded brackets that hold the leg in place and move them…