Replacement Control Module for Coach Step with 2023230 Module

Question

Question:

My steps are not retracting when my door closes or opening when door opens. It has a controller 202-3230 and a 725-0031 step assembly. Can you advise what i need and price?

asked by: Randy B

0

Expert Reply:

Since it won't open or close at all with the door switch you'd need a new controller which would be part # LC301702.

expert reply by: Jameson C

0

Answer 1

The purple wire of the Coach Step Module part #LC301702 that you referenced is for the step light switch. It is designed to send power to the step light switch so that the light comes on.

view full answer...

Answer 2

The Lippert 165046 upper slide assembly you have has been discontinued. We sell replacement parts for it but not the entire unit. The Replacement Motor for Lippert Electric Coach Step item #LC301695 Replacement Control Module for Lippert Electric…

view full answer...

Answer 3

The replacement motor you'd need is the part #LC301695 and you'd be set.

view full answer...

Answer 4

The Replacement Control Module for Lippert Electric Coach Step Item #LC301702 will replace the control module on any Coach Step from Lippert.

view full answer...

Answer 5

The replacement control module that you need for your 202-3207 control module on your Coach Steps is the Lippert part #LC301702 on our site. I reached out to my contact at Lippert who said this control module is the correct replacement for all of the…

view full answer...

Answer 6

The Replacement Control Module, part #LC301702 is just what you need to replace the Frigette 202-3230 controller on your RV steps. This unit installs under the step base and requires 4 screws for installation which are not included.

view full answer...

Answer 7

In order to get your steps back up and running you are going to need to install the update kit, the Motor Upgrade Kit for Kwikee 26 Series Electric RV Steps part #LC379801. The update kit is your only option because they no longer offer a replacement…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Replacement Control Module for Coach Step with 2023230 Module

Product Page this Question was Asked From

Continue Researching