How Much Voltage Is On Cold Side Wire Of Vehicle Stop Light Switch?
Question:
What voltage is suspected on stoplight switch when pedal is pushed
asked by: Bert G
1
Helpful Expert Reply:
The cold side wire of the stop light switch that only has power when the brake pedal is pressed has a full 12 volts.
Using a circuit tester like # PTW2993 will help you find the correct wire to connect your controller to.
I included a link to a helpful article on installing a trailer brake controller for you to take a look at.
expert reply by:
Samuel C
1
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Q&A: Where is Cold Side of Brake Switch Normally Found
- Shop: Dexter Trailer Idler Hub Assembly for 5,200-lb to 7,000-lb E-Z Lube Axles - 8 on 6-1/2
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Shop: B&W Heavy-Duty Ball Mount - 1" Rise, 2" Drop - 8-1/2" Long - 16,000 lbs
- Shop: Buyers Products Tri-Ball Hitch - Tubular Shank with Chrome Balls
- Shop: Quick Splices - Self-Stripping Connector - Closed Port - 10-12 Gauge - Yellow - Qty 1
- Shop: Dexter Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Shop: Jacketed 2 Wire (Brake Wire) - 12 Gauge - per Foot
- Shop: 3/4" x 60' Electrical Tape
- Search Results: gnrk1116
- Search Results: electrical tape
- Search Results: wire connectors
- Search Results: brake wire
- Search Results: scissors
- Search Results: bmhd30010
- Search Results: crimp connectors
- Shop: Gooseneck Hitch
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Can Tekonsha Primus IQ Install in Kenworth T370
- Q&A: Recommended Brake Controller for a 2006 Kenworth T300 w/ Air Brakes
- Shop: Trailer Wiring
- Video: Trailer Wiring Harness Installation - 2012 Volkswagen Touareg
- Video: Trailer Wiring Harness Installation - 2010 Volkswagen Touareg
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Q&A: Why is a Relay Needed When Installing a Tekonsha P-3 Brake Controller # 90195 on a 2008 VW Touareg
- Q&A: Diagram For Brake Controller Installation on a 2006 Volkswagen Touraeg V10
- Video: Tekonsha T-One Vehicle Wiring Harness Installation - 2018 Volkswagen Atlas
- Q&A: How To Install a 7-Way Trailer Connector On a 2021 Volkswagen Atlas
- Video: Curt Brake Controller C51522 Review