2019 Jeep Sahara Unlimited Brake Light Indicator
Question:
I am installing an invisibrake system. There are three wires coming from the brake light switch. Which one do I connect to make the indicator light work on the motor home.
asked by: Bobby
0
Expert Reply:
To determine which wire carries the brake signal you would need to voltage test each wire while depressing the brake pedal. The one that powers on and off with the brake pedal actuation is it. It is recommended that you use the RM-751490 Stop Light Switch Kit to facilitate this installation. I have include a link below.
expert reply by:
Les D
0
Products Referenced in This Question
Roadmaster Universal Stop Light Switch Kit
- Tow Bar Braking Systems
- Stop Light Switch
- Roadmaster
more information >
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Equa-Flex and Road Armor Equalizers For 2000 Forest River WIldwood W/ 5200lb Axles
- Q&A: Equalizer Replacement Options for Dexter 13-122 Equalizer
- Q&A: Replacement Electric Brakes for Dexter PR-FF SEC-FF 5.2KPR-GGSEC-GG 12X2XQ 36-89
- Q&A: Replacement 12 inch Brake Assemblies for Dexter 36-89 on Trailer
- Article: How to Rent an RV
- Q&A: Oil Seal for 10K Quality Axles with Seal 27438
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Q&A: Can 12 Volt Battery Replace Two 6 Volt Batteries
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Must-Have Flat Towing Components
- Article: What Exactly is Tongue Weight?
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)