Repair Kit for Venture RV Landing Gear Legs

Question

Question:

IS THE VMC900L-367015 IS THE SAME AS VMC900L-433157

asked by: ROBBIE M

0

Expert Reply:

As far as repair kits go yes the two part numbers are the same. If you needed to repair the follow leg you'd need the # LC146060 or for the lead leg # LC146059.

expert reply by: Jameson C

0

Answer 1

I went out to the warehouse and measured the shaft included with the Lippert Components Venture Follow Leg Repair Kit #LC146060. It has an overall length right at 4 inches.

view full answer...

Answer 2

The Lippert Venture Lead Leg Repair Kit #LC146059 is the correct repair kit for the lead leg on your VMC900. The Kit #LC146060 is for the follow leg. I do recommend disassembling your leg to ensure the reason it is seized is the gears and not due to…

view full answer...

Answer 3

The only follow leg I can recommend you use with your Venture landing gear would be the part #LC179014. Stromberg Carlson makes the Venture landing gear, that is the brands are different but the jacks are the same. I cannot recommend you install a…

view full answer...

Answer 4

According to our information you'll need the Replacement Lead Leg #LC119102 for your Venture VMC900L landing gear kit. If you end up needing the follow leg as well that can be found on our site as part #LC119101. Attached is a review video for…

view full answer...

Answer 5

Although we do offer replacement bevel gears for landing gear legs, none of them match the dimensions that you provided for your bevel gears unfortunately. I can only imagine you are going to have a really tough time finding just the bevel gears for…

view full answer...

Answer 6

Yes, I checked with Torklift and the correct rear camper tie down for your 2020 GMC Sierra 1500 dual exhaust with running boards is the part #TL54FR.

view full answer...

Answer 7

Thanks for all the information! You are correct that is the lead leg because it is closest to the gear and the motor. However, in order to determine which replacement lead leg you need, you'll need to find the model of the landing gear on your…

view full answer...

Answer 8

Due to the measurements you have on your VMC900L, you will actually need the Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2" #LG-177201. This will match all your measurement and I included a review video laying all these…

view full answer...

Answer 9

The correct landing gear leg for your 2004 Keystone Cougar 254EFS is more than likely going to be either the Replacement 29-1/2" Long Follow Jack part #LG-179014 or the Replacement 33-1/2" Long Follow Jack part #LG-177201. In order to…

view full answer...

Answer 10

Thank you for the photo of your trailer landing gear interior. We can help you with a repair kit for the lead and follower legs of your Venture landing gear. For a lead leg repair kit use #LC146059 and for the follow leg use kit #LC146060. It is hard…

view full answer...

Answer 11

Based on what your VMC900L has wrong with it the best option would be to replace the lead leg with part #LC119102.

view full answer...

Answer 12

In order to determine which replacement lead leg you need on your 2005 Keystone Challenger, you'll need to know the model of the landing gear on your trailer (we have no way of knowing what you have), and measure it's outer tube length. For…

view full answer...

Repair Kit for Venture RV Landing Gear Legs

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching