Is There Supposed to Be a Small Gap Right Behind Where the Bolt Holds the Bumper?
Question:
If I attach the hitch the way the instructions say there is going to be a small gap between the Frame and the Hitch. Right behind the The bolt that holds the bumper. is this gap ok. I highlighted the area in question in a photo. See attached.
asked by: Pat
0
Expert Reply:
I confirmed with my contact at Curt that this gap is normal for fitting the Curt Class III Hitch # 14374 on a 2018 RAM 1500.
expert reply by:
Bob C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: How Does the Curt Hitch Attach to the 2021 Dodge Warlock?
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Q&A: Mounting Hole Dimensions For Curt Trailer Hitch On 2014 Dodge Ram 1500
- Q&A: Class IV Receiver Hitch for 2019 Dodge Ram 1500
- Article: Determining Trailer Tongue Weight
- Q&A: Can OEM Hitch on 2015 Ram 1500 Be Welded to Frame to Increase Towing Capacity
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Replacement RV Air Conditioner for Carrier Unit with 13.5k BTU
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Bulb For A Heng's Jensen JRP1007B Range Hood Light Bulb