Troubleshooting Titan Electric Over Hydraulic Brake Actuator T4813100 Not Engaging Brakes
Question:
2019 CHEVY P/U HAVE TITAN EOH CONTROLLER FOR BOAT TRAILER I HAVE THE CONVERSION BOX FOR THE CHEVY ON IT HAD NOTHING CLEANED ALL THE WIRES AND NOW WHEN I USE THE DASH BRAKE CONTROLLER I HEAR THE UNIT RUNNING BUT NO BRAKES I PULLED THE MOTOR OFF OF IT AND WHEN I PUSH THE DASH BRAKE CONTROLLER I CAN SEE IT RUNNING SHAFT TURNS PLENTY FLIUD AND ADJUSTED DASH CONTROLLER UP TO 10 STILL NO BRAKES I CANT TELL WHAT THAT MOTOR SHAFT LIKE A SPADE GOES INTO DOWN IN THE CONTROLLER ANY IDEAS PLEASE AND THANKS
asked by: DONNIES B
Expert Reply:
The issue you are describing with Titan BrakeRite EHB Electric-Hydraulic Actuator for Disc Brakes T4813100 sounds like it is not building enough pressure to engage the brakes on your trailer.
I recommend using a volt meter and checking the black and white wires on the actuator while the trailer is connected to your truck.
When the brakes are NOT applied you should have 12 volts, and when the brakes are applied you should not see less than 10 volts. If you are seeing less than 10 volts when the brakes are applied there is a short in the wiring causing the issue, and causing the brakes to not engage.
You will need to check the wiring coming from the actuator back to the connector, and then on the vehicle side looking for any damaged wiring.
If you are getting at least 10 volts the issue is inside of the T4813100 and it will need to be replaced.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Article: Troubleshooting Brake Controller Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working