Diameter of Mounting Holes in Optronics MCL93RB LED Identification Light Bar
Question:
Hello, It appears two 2 screws / bolts are require to hold this fixture onto the boat trailer... 1 - What size screws / bolts / washers / nuts are required to hold this light fixture onto the boat trailer frame? 2 - What is the recommended hole size for the screws / bolts? Thank you
asked by: Patrick S
Expert Reply:
The mounting holes for the # MCL93RB ID Light Bar are 3/16 inches in diameter, I'd recommend using 3/16 inch stainless hardware and a 7/16 hole in the trailer frame. Stainless bolts, nuts and washers should be readily available at your local hardware store.
If you click the provided link, you can see a product demonstration video for the # MCL93RB Light Bar.
Product Page this Question was Asked From
LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 15-15/16L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Replacement Parts for ELX-45 Power Converter
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Q&A: Replacement Leaf Spring Bolts and Bushings for Dexter 10K Axle On Big Tex Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates