Troubleshooting a Brake Controller that is Not Activating Trailer Brakes
Question:
brake controller in truck reads normal but when i apply brakes with trailer wheel off ground it doesnt stop spinning
asked by: Krk
Expert Reply:
So your brake controller seems to be functioning but the brakes are not applying on your trailer. The first place I would check would be the brake output circuit on the trailer connector that is on your vehicle. You will want to use a circuit tester like the # PTW2993 to test for voltage on this circuit. I attached a video that shows you the idea on how this is done, but you will be testing the brake output circuit for voltage that ramps up while a buddy applies the brakes. I attached a pic of what the 7-way should look like also.
If the voltage looks good there then you know the problem is not on your tow vehicle and is in your trailer wiring.
A lot of times corrosion on the connectors or cut/exposed wires are the culprit. I would check for this on both trailer connectors.
There is also the chance that your brakes could be out of adjustment. Check out the video I attached on trailer brakes that show how this is down. Fast forward to the 4:40 mark to see the adjustment.
Nearly all trailer wiring problems are ground related. I would next recommend you check the grounding of the wires of the brake assemblies and then check the conditions of the brake output circuit wires on your trailer.
I attached an FAQ article on trailer wiring for you to check out also.
Products Referenced in This Question
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Shop: Hook Probe Circuit Tester
- Shop: Hopkins Trailer Breakaway Kit with Built-In Battery Charger - Side Load
- Q&A: Can Redarc Tow-Pro Elite # RED44FR Be Installed In a 2020 Ford Ranger W/ Factory 7-way Connector?
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2019 Ford Ranger
- Shop: Curt Soft Trac II Trailer Breakaway Kit
- Shop: Hopkins Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Search Results: hopkins breakaway switch
- Search Results: emergency brake
- Q&A: Does a Breakaway System Battery Affect Everyday Trailer Brake Performance
- Q&A: If One Brake Magnet Goes Bad, Will Other Brakes Still Work?
- Search Results: ptw2993
- Q&A: Why is Trailer Brake Controller Flashing N.C.
- Q&A: How to Release the Brakes on a Trailer Once the Break Away Switch Is Activated
- Q&A: Can You Test The Redarc Trailer Brake Controller Installation Without Connecting To a Trailer?
- Q&A: Plug and Play Brake Controller Installation for 2020 Ford Ranger with Factory 7-Way
- Search Results: 331~tpsi~003
- Shop: Towing Mirrors
- Video: K Source Dual Lens Universal Towing Mirrors Review
- Shop: K-Source Universal Dual Lens Towing Mirrors - Clip On - Pair
- Video: Review of Redarc Trailer Brake Controller - Tow Pro Liberty Proportional Controller - RED24FR
- Shop: Vehicle Cargo Control
- Shop: Truck Bed Rail Caps
- Shop: Tonneau Cover
- Video: Review of Redarc Trailer Brake Controller - Tow-Pro Elite - RED44FR
- Video: Access TonnoSport Soft Roll-Up Tonneau Cover Review
- Video: Review of Dometic RV Water Heaters - Gas and Electric Water Heater - DMC74FR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Wiring
