Does EcoHitch for 2019 Chevy Silverado Have Hitch Opening Behind License Plate

Question

Question:

Hello, I have a 2019 Chevy Silverado 2500HD Duramax and want to install a front hitch. I see there are two different ones on your site that will work. I really like the EcoHitch Item # 306-X7906 as it has a higher line pull and tongue weight. My questions, what is the height of the hitch receiver after its installed? And what is the location of the receiver? I see in some photos the receiver is below the license plate, the description mentions it is behind the license plate. Thanks,

asked by: Joe C

0

Expert Reply:

The EcoHitch Invisi Front Mount Trailer Hitch Receiver # 306-X7906 that you referenced does have the hitch opening height at the same height as the current license plate height. This is why this comes with a license plate bracket that fits into the hitch opening when the hitch is not in use.

expert reply by: Jameson C

0

Answer 1

Draw Tite has a front hitch that fits your 2018 Chevy Silverado 3500 with the part #65078 which has a vertical load limit of 500 lbs or we have the EcoHitch part #306-X7906 which is actually rated for 1,000 lbs. Either of these would work really…

view full answer...

Answer 2

For your application I recommend using the EcoHitch Invisi Front Mount Trailer Hitch Receiver #306-X7906. This will fit in a cutout you make on the front bumper of your 2019 Chevy Silverado 2500 and it comes with a magnetic license plate mounting…

view full answer...

Answer 3

I do not have a completed installation photo nor did EcoHitch, but I can provide a photo showing where the receiver tube will sit in relation to the bumper. You'll need to make a hole in the fascia under the bumper directly behind where the front…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 10

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 11

view full answer...

Answer 12

You always need to keep your trailer tires filled to the max cold psi rating. If your current load range G tires have a 110 psi rating then that is what you need to keep them filled to. Tire blowouts are a result of damaging a tire (like hitting…

view full answer...

Does EcoHitch for 2019 Chevy Silverado Have Hitch Opening Behind License Plate

Product Page this Question was Asked From

Continue Researching