Is the Adarac Aluminum Series Custom Ladder Rack Compatible with a Pace Edwards Switchblade

Question

Question:

Hello. Are these two compatible? It is for an 2021 F150 5 1/2 foot bed. Pace Edwards Switchblade Retractable Hard Tonneau Cover - Aluminum and Vinyl - Black - PE29UV AND Adarac Aluminum Series Custom Truck Bed Ladder Rack - Aluminum - 500 lbs - Matte Black - A66RR Thank you

asked by: Juli P

0

Expert Reply:

Yes. The Adarac # A66RR is compatible with the Pace Edwards Switchblade # PE29UV since the Adarac sits on top of the bed rails and the Switchblade mounts inside the rails. Because this is a fully retractable cover it's not going to be obstructed by the rails or uprights on the Adarac, so they make a great pair.

expert reply by: Erik B

0

Answer 1

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 2

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 3

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 4

Hey Chad, so I'd actually recommend a mid size ladder rack like the Yakima OutPost HD Overland Truck Bed Rack #Y01152-58. This is by far going to be your best bet if you don't want to trailer your kayaks. These bars have a 500 lb weight…

view full answer...

Answer 5

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 6

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 7

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 8

From your question it sounds to me like someone has cut off the tow package plug on your 2005 Ford F-150 and wired in a 4-way connector. In this case you could use the Hopkins Adapter 4-Pole to 7-Pole and 4-Pole, #37185 which will give you a 4-way…

view full answer...

Answer 9

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 10

Yes, to both of your questions! The Mountain Top EVO-M Retractable Hard Tonneau Cover with T-Slot Accessory Rails - Aluminum item #MNT29FR is confirmed to fit the 2021 Chevy Silverado 1500's with a 6-1/2' bed. It is also compatible with the…

view full answer...

Answer 11

Yes, the Thule TracRac SR Sliding Truck Bed Ladder Rack #TH57RV will fit your 2020 Ram 1500 with the 5'7" bed and no Ram box. Unfortunately, this rack is only available in the silver color. We do offer the TruXedo Elevate Truck Bed Rack…

view full answer...

Answer 12

Hey Brian, the Pace Edwards Full Metal JackRabbit part #PE36CV that you referernced has a 300 lb weight capacity when spread evenly on the cover. The Retrax Pro XR on other hand has a 500 lb capacity.

view full answer...

Is the Adarac Aluminum Series Custom Ladder Rack Compatible with a Pace Edwards Switchblade

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching