Go Power Recommendations for Portable Systems

Question

Question:

I have a question about: Go Power Solar Cable Entry Plate with Red and Black MC4 Cables - 10 Long - 34273841REVA. Is this meant for quick disconnect applications for solar panels? I plan on using this for hooking up solar when setting up camp. I want to be able to disconnect when traveling. Thanks. -Logan

asked by: Logan M

0

Expert Reply:

The Go Power Solar Cable Entry Plate 34273841REVA with MC4 connections, as installed by RV builders, is generally installed on the roof. If this is the situation with yours then this will not provide a quick disconnect for you unless you use an MC4 to SAE for creating a quick disconnect. The MC4 entry plate is intended to make connections for permanent/semi permanent solar panels affixed to the roof.

I suggest the Go Power Portable Solar System with Digital Solar Controller and 200 Watt Solar Panel # 34282610. This is also available in a smaller 90 Watt Solar Panel arrangement, # 34282729. Or the 130 Watt, # 34282730. Either way you go, I caution you to not operate a solar system without a charge controller or operate sensitive electronics without a pure sine wave inverter such as the Go Power Industrial Pure Sine Wave Inverter - GFCI - 1,000 Watt - 12V Item # 34279948.

expert reply by: Michael R

0

Answer 1

You could use larger MC4 cable gauge wire from the Go Power Solar Cable Entry Plate #34273840 to your controller but it wouldn't benefit you very much unless you used larger gauge wire from the solar panel to the entry plate. Larger gauge wire…

view full answer...

Answer 2

I wouldn't go larger than 10 AWG with the Go Power Solar Cable Entry Plate for MC4 Cables #34273840. The larger wire will just make sure that you are getting enough power to your entry plate from the solar panel. I recommend going with an option…

view full answer...

Answer 3

We have a few different options for the Go Power Solar Cable Entry Plates like the part #34273841REVA that you referenced. The only real difference is the length of the cable that it comes with. The one you referenced comes with 10 feet of cable…

view full answer...

Answer 4

The wiring of the Go Power Solar Cable Entry Plate with Red and Black MC4 Cables #34273841REVA is tinned copper.

view full answer...

Answer 5

Since you have an aluminum trailer I suggest using a tie-down that has a backing plate like #RR5K. This will help reinforce the tie-down since aluminum may not hold up. It would be even better if you can install the tie-downs to the frame of the…

view full answer...

Answer 6

The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.

view full answer...

Answer 7

The orientation of the backing plate on the Brophy D-Ring Tie Down Anchor w Backing Plate part #RR5K does not matter. I called my contact at C.R. Brophy Machine Works to confirm this as well. The reason one side is longer is because different…

view full answer...

Answer 8

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 9

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Go Power Recommendations for Portable Systems

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching