Will Draw-Tite Trailer Hitch Receiver 41935 Fit My 2008 Toyota Tundra With Aftermarket Rear Bumper?

Question:

My factory installed hitch was worn out and the bumper was beat up pretty bad. I removed both the bumper and hitch and only replaced the bumper with an aftermarket bumper and brackets. Can i now use the drawtite hitch 41935 on my truck?

asked by: Joe S

Helpful Expert Reply:

The Draw-Tite Ultra Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2" # 41935 is an excellent choice and is confirmed to fit your 2008 Toyota Tundra. You likely will not have an issue, but it really depends on if your aftermarket rear bumper hangs lower than the factory bumper.

To determine exact fitment in your situation, you will want to measure from the ground to the bottom of your bumper. This hitch measures 18-1/4" from ground to top of hitch receiver when the truck is equipped with factory suspension height. If your measurement from the ground to the bottom of the bumper is more than 18-1/4" then you will not have an issue. If you have a lift kit or different suspension then you will need to take that into consideration when comparing measurements. I have attached an installation video for this trailer hitch receiver.

expert reply by: Andrew N