Can Lippert Stabilizer Jack Set Install on Front and Rear of Trailer  

I went out to our warehouse and test fit some SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 and found that the 6" square SnapPads were a fit. If your 2022 Forest River Vibe travel trailer only has one #LC298707…

In regards to the Lippert Components High-Speed Power Stabilizer Jack like part #LC298707, the first thing I would do is check voltage on your battery to make sure it is above 12.4 volts. If it is not then you have a dead battery and it will need to…

The mounting holes on the Lippert High-Speed Power Stabilizer Jack part #LC298707 are 68-11/16" apart side to side on center. This fits a standard-ish trailer frame spacing. That said, there are other frames outside of this spacing and in which…

The circuit rating for the motor on the Lippert High-Speed Power Stabilizer Jack part #LC298707 is 20 amps so you'll need to use this along with the distance between the jack motor and battery to find the correct size wire. You can find charts…

To extend/retract the Lippert High-Speed Power Stabilizer Jack #LC298707 you will need to press and hold the the switch, as there is no automatic cut off. However, this jack does have an integrated circuit breaker to protect you from damaging your RV…

Yes, you can still raise and lower Lippert Components Power Stabilizer Trailer Jack Item #LC298707 even if the switch goes bad or electrical power is lost for any reason. In order to operate the jack manually there are a few steps: First always…

For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…

Yes, the Lippert Components Power Stabilizer Trailer Jack #LC298707 that you referenced does include the switch and breakers needed to complete the install.

You do not necessarily need to add the Lippert Components Double Spacer for RV Electric Stabilizer Jack #LC266030 to your new Lippert Components High-Speed Power Stabilizer Jack #LC298707. If you install your new stabilizer and find you need the…

The mounting dimensions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 are 68-11/16" from center-hole to center-hole. Since this stabilizer jack is a universal fit the only way to know if it is compatible is to make sure…

I attached a picture that I got from Lippert that shows the wiring diagram for their stabilizer jacks like the part #LC298707.

Between these three, the difference is the included parts. Part LC337199 is discontinued but did not include a switch at all, while part #LC369774 has a white switch and housing, and part #LC298707 has a black housing. All three of the systems are…