Mounting Hole Diameter for Titan 2-Tang Clevis

Question

Question:

What is the diameter of the two mounting holes?

asked by: Charlie

0

Expert Reply:

The diameter of the mounting holes of the # T0897900 are 5/8 inch. We also have this as a kit with the channel and mounting bolts/nuts with part # T1812200.

expert reply by: Jameson C

0

Answer 1

The mounting holes are 2 inches on center for the clevis and 3 inches on center for the mount. The clevis and side of the bracket has holes that are 0.64 inch. The top and bottom holes of the mounting bracket are 0.48 inches and the center hole is…

view full answer...

Answer 2

The mounting holes are exactly 2 inches on center apart on the Titan 2-Tang Clevis part #T1807800. I have attached a very helpful video that points out the measurements for you.

view full answer...

Answer 3

That is a pretty good guess! The two position mounting channel in the #T1812200 is 3-1/2" wide x 7-1/2" tall as shown in the included diagram. I included a video review of the #T1812200 for you to take a look at.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Mounting Hole Diameter for Titan 2-Tang Clevis

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching