Recommended Step/Walkway for Boat Trailer Tongue

Question

Question:

Do you carry any type of trailer tongue walkway platform for boat trailers.

asked by: Jim T

1

Helpful Expert Reply:

I do have step options which can be mounted to the tongue of a boat trailer but we don't have any sort of walkway platforms that you were referring to. I recommend the HitchMate Boat Trailer Step part # HE4036 which will fit any tongue up to 3" wide x 5" tall and provides a nice 5" wide x 9" long step.

expert reply by: Conner L

1

Answer 1

Tire size 4.80-12 is not found on vehicles, but is a common trailer tire size on smaller utility- and sport-type trailers. In trailer use you do want to inflate them to the maximum cold psi pressure noted on the tire sidewall. Trailer tires should…

view full answer...

Answer 2

The trailer tire manufacturers we work with all have recommended the information you have seen given in our online answers. The max PSI from most manufacturers the listed capacity at the highest load capacity rating of the ST tire. There are charts…

view full answer...

Answer 3

It sounds like you are trying to add some steps to the tongue of your boat trailer for help getting in the boat. If that is the case then only bolt-on option we'd have is the HitchMate Boat Trailer Step part #HE4036 which bolts onto the frame.…

view full answer...

Answer 4

Sounds like you are looking for the HitchMate part #HE4036. This is a trailer step that attaches to the tongue of a trailer and gives you a step. Check out the review video I attached as well.

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Recommended Step/Walkway for Boat Trailer Tongue

Product Page this Question was Asked From

Continue Researching