Tekonsha Voyager Brake Activator # 39510 Wiring Directions
Question:
i need to know what the wires go to out of the back of a voyager brake controler i am rewiring them and i dont know what they go to for shure and and which ones get ran back to the round seven plug
asked by: Dustin B
Expert Reply:
You should have four wires coming out of the back of your Tekonsha 9030 Voyager Brake Activator, # 39510. They should be white, blue, red, and black. The white wire is the ground wire. The red wire must tap into the cold side of your vehicle brakes. You will need to use a circuit tester like # PTW2993 to find this wire. It will be the wire that carries a signal only when the brake pedal is pressed.
The blue wire is for electric brake controller out put and will run to the trailer connector on the back of your vehicle. If looking at the back of the connector where the wires go, it is the pin in the 7 oclock position. The black wire must run to your battery to power the brake controller via a 20 or 30 amp circuit breaker. See brake controller instructions, linked below, for which size to use.
I have included a link showing the installation of this brake controller and a link to our trailer wiring FAQ article that should help.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Best Camper Jacks
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)