Setting the Gain and Getting Ready to Tow with the Brake Controller on a 2012 Ram
Question:
My controller only goes up to 1.0 when using the brake pedal. When I slide the lever I get full 10 power braking. Is this normal? Also is the yellow trailer symbol on the controller supposed to be lit when connected to a trailer ? Mine is not
asked by: Patrick B
Expert Reply:
It sounds like you need to adjust the gain on your controller. The + and - buttons will raise/lower the setting. If the controller is set at 1.0, then that's as high as it will go when you press the brake. Use the + button to set this to a higher number, and that new number will be the new cap when you press on the brake.
The TOW/HAUL indicator light will not light up when connected without pressing the TOW/HAUL button on your center console. This is important as your 2012 Ram will not recognize it is towing a trailer until that is pressed.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Article: Troubleshooting Brake Controller Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working