4-Way Trailer Connector for 2002 Jeep LIberty

Question

Question:

Hello and thank you for being here. I have a 2002 Jeep Liberty and need to replace my 4-pin vehicle trailer wiring kit 3 female/1 male to connect to the trailer which has the wiring set. Cant seem to locate. Thank you!

asked by: Mark C

0

Expert Reply:

We do have 4-way trailer connectors you can install on your 2002 Jeep Liberty, with the correct one depending on if you have the factory tow package or not.

If you do have the factory tow package on your 2002 Liberty, the correct 4-way harness is the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 42475.

If you do NOT have the factory tow package on your Jeep, the correct 4-way harness is the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118524.

expert reply by: Kyle S

0

Answer 1

The Hopkins #42475 Trailer Wiring Harness is compatible with all models of the 2003 Jeep Liberty, regardless of whether it has the tow package or not. I've confirmed this with my contact in the Tech services department at Hopkins.

view full answer...

Answer 2

You will plug the Hopkins Plug-In Simple Vehicle Wiring Harness #42475 into your 2007 Jeep Liberty at the connectors which are behind the rear paneling on the passenger side. I have added a cut out which is from the linked directions that shows…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #42475 you were looking at is confirmed to fit your 2004 Jeep Liberty Sport and will not require any additional fuses and does not require any upgrade to your…

view full answer...

Answer 5

The most efficient way to determine if your vehicle has the tow package is to take your VIN number to a Jeep dealer and have them run it. They will be able to tell whether or not you have the tow package with that information. Or you could check the…

view full answer...

Answer 6

On your 2007 Jeep Liberty, If you are referring to the red wire on the brake controller, it attaches to the wire on the stoplight switch that carries a signal only when the brake pedal is pressed. You will need a circuit tester, like #PTW2993, to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 9

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...