Could Epicord Battery Disconnect Switch Be Used on Trailer with Dual Batteries
Question:
I have dual batteries on our travel trailer, will this work?
asked by: Peter N
0
Expert Reply:
Yes you could use the Epicord Battery Disconnect Switch # 277-000096 on a travel trailer that has a dual battery setup. Your batteries are most likely wired in parallel and use one of the terminals of each battery as a power and ground for the rest of the trailer's wiring. You'd just need to install this on one of those wires and you'd be set.
I attached an install video for this for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Epicord Battery Disconnect Switch with Key - 50 Amp
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- Epicord
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting Curt Echo Brake Controller Not Getting Power/Not Connecting to iPhone
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Q&A: Can 2019 GMC Sierra 1500 Denali be Flat Towed and Parts Needed
- Article: Best Bike Racks for Electric Bikes
- Q&A: Recommended Replacement For An Atwood GCH10A-4E RV Water Heater
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Recommendation For License Plate Mounting Location On A Jet Ski Trailer
- Article: Performance Chips and Modules
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: Roadmaster Vehicle Specific Base Plates