Gen-Y Hitch Loading Ramps # 325-GH-R96 for a 5,000 lb Scissor Lift
Question:
im looking to use these to load a scissor lift on my trailer and note i do use a winch to pull it up on the trailer, the lift weighs 5000 lbs . do you think this is ok?
asked by: Paul
Helpful Expert Reply:
Each ramp included with the Gen-Y Hitch Aluminum Loading Ramp Set # 325-GH-R96 can support up to 5,000 lbs each for a total of 10,000 lbs when the equipment being loaded is supported by both ramps. This weight capacity will be more than enough to use with your 5,000 lb scissor lift as long as you are able to use both ramps to support the weight of the scissor lift. Of course, your trailer will also need to be rated high enough to handle the 5,000 lb scissor lift. Check out the video linked below for more details on using this product.
Product Page this Question was Asked From
Gen-Y Hitch Aluminum Loading Ramp Set - 8' Long x 15" Wide - 10,000 lbs
- Car Ramps
- Loading Ramps
- Open Trailer
- 15 Inch Wide
- 96 Inch Long
- Car Hauler Ramps
- 10000 lbs
- Gen-Y Hitch
more information >
Continue Researching
- Q&A: How to Determine the Correct Replacement Bearings for a Trailer
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Article: Big Truck Big RV
- Q&A: Replacement Key Needed for Gorilla Guard Trailer Coupler Lock
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Q&A: Factory Brake Wiring Harness Location on 2012 Chevy Silverado
- Article: Pintle-Hitches
- Article: Best Ladder Racks
- Q&A: Scissor Jack Recommendation to Replaced Damaged Ones on R Pod Trailer
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Jacks