What Are the Instructions for Installing a Cargo Glide 1000XL Sliding Tray
Question:
install instructions please
asked by: Gerald P
Expert Reply:
I've linked the instructions for installation of the Cargo Glide 1000XL Sliding Tray for Trucks # CG1000XL-7548 to this answer for you to have a look at, as well as some more abbreviated ones below.
The CargoGlide can be installed in a few simple steps. It's designed to be attached at 4-6 points in your truck bed using PlusNuts and bolts - all part of the included hardware packet. You will need the following tools: tape measure, crescent wrench, drill, knife, 5/16" bit, 1/2" bit, 1/2" socket, and a ratchet or impact driver.
The steps are straightforward (consult manual for full instructions):
1- Position the CargoGlide in your truck bed and determine clearances (you will need another person to help lift)
2- Locate and mark attachment points. Make sure there are no gas lines or other obstructions under the truck or van bed where you plan to drill.
3- Drill the pilot holes installation holes.
4- Install PlusNuts, bolts, and washers. Then tighten bolts.
