Correct Replacement For a Stabilus 654150 Gas Strut

Question

Question:

Replacement shock

asked by: Joseph

0

Expert Reply:

Your Stabilus strut measures about 26-1/2 inches when extended and exerts 120 lbs of force. The Lippert Solara # LC280343 strut you'd looked at is almost identical, at about 26-1/2 inches when extended with 124 lbs of force. The strut is right at 15 inches long when retracted, so if that favorably matches up with your existing strut, it'll be a good repalcement.

expert reply by: Mike L

0

Answer 1

Though we don't carry that exact part, we do have a strut with the same dimensions that is likely to work. Based on my research the gas strut 654150 is 26.46" when extended, has two metal ends and is 120 lbs of force. The strut we carry…

view full answer...

Answer 2

I do have a suggestion, because we have a gas strut with with dimensions that are the same as the Stabilus 654150 which is likely to work; the Stabilus strut measures 26.46" when extended with 120 lbs of force. The nearly identical strut we…

view full answer...

Answer 3

The Stabilus Lift - O -Mat 654150 has a length of 26.46". I do not offer a direct replacement, but the Solera Gas Strut 26", 124 lbs for Short and Flat Awning Arms, part #LC280343, will work for you if the eyelet connections are the same.…

view full answer...

Answer 4

The Solera Gas Strut 26", 124 lbs for Short and Flat Awning Arms #LC280343 does not come with push nuts, you will need to locally source these. You can do this at any hardware store.

view full answer...

Answer 5

I have a solution for you but we do not carry an exact replacement for the 654150 0550N 091/16 strut . The strut we carry that is almost the same is the Solera Gas Strut for Short and Flat Awning Arms item #LC280343 that you were looking at. The…

view full answer...

Answer 6

Assuming you got the correct strut from Amazon if you have the #LC280343 on your RV currently this should be the correct replacement. There isn't an easy way to install these wrong as well so it's also possible the ones you got are bad. Older…

view full answer...

Answer 7

While we do not carry the exact strut you're looking for, we do carry an alternative that has the same dimensions as the Stabilus 654150. Take a look at the Replacement Gas Strut for Short and Flat Solera RV Awnings #LC280343. This strut has the…

view full answer...

Answer 8

It sounds like you're looking for the torque specs for the lug nuts on a 6,000 pound axle. For a hub with 1/2 inch studs, 90 to 95 foot-pounds is standard.

view full answer...

Answer 9

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 12

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Correct Replacement For a Stabilus 654150 Gas Strut

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching