What Size Hole Saw to Install Epicord Batt Disconnect #277-000096

Question

Question:

What size hole saw is needed to drill thru the header in order to mount this part?

asked by: Jv

0

Expert Reply:

To easily fit the center portion of the Epicord Battery Disconnect Switch # 277-000096 through your wall you'd want to drill a 2-3/4 inch hole so that would be the size hole saw to use.

expert reply by: Jameson C

0

Answer 1

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 2

Hey Albert, the correct replacement lithium compatible converter for the part #PD9245C is the part #PD69RR which has same amperage output of 45 amps at the correct voltage for lithium batteries.

view full answer...

Answer 3

The difference between the two models that you were researching is that the #PD9160A is designed for use with lead acid batteries and the #PD9160ALV is designed for use with lithium batteries. Choosing the incorrect battery profile can lead to issues…

view full answer...

Answer 4

Hey Dave, for a 60 amp charger the 6-gauge wire that you have currently is not going to cut it. You will want to use 4-gauge copper wire for your 15' run when using the Progressive Dynamics PD9200 Series Battery Converter Charger #PD9260C. For a…

view full answer...

Answer 5

Unfortunately Shawn, I have no way to see what parts were installed on your 1995 Hitchiker 2. As you have a standalone power converter you will need to look at your converter to see its power output in amps. Here is a list of the different sizes by…

view full answer...

Answer 6

Hey Phil, the correct 60 amp converter replacement that is Lithium compatible is the Progressive Dynamics part #PD79RR. This charges at the higher voltage required by lithium batteries.

view full answer...

Answer 7

I have a few things for you to check when it comes to not being able to pair your iPhone with the Curt Echo #C51180. The first thing to do is make sure that you're pairing your phone with the Echo through the app. If you paired it through the…

view full answer...

Answer 8

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 9

I took a look at the owner's manual for a 2019 GMC Sierra 1500 Denali and both it and the standard 1500 can be flat towed so long as it is a four-wheel drive with a two-speed transfer case, and according to page 236 of the manual, "To shift…

view full answer...

Answer 10

If you have already added the fuse and the trailer charge circuit is not activated in the 2019 Ford F-350 Super Duty with factory integrated brake controller, then you want to make sure the trailer is connected and you press the brake according to a…

view full answer...

Answer 11

First of all you will need the Roadmaster Direct-Connect Base Plate Kit 524470-5 #RM97RR for your 2024 Ford Maverick. The item #RM39FR you found is Roadmaster part number 524465-5 which fits certain Ford Escapes. Do understand the baseplate above…

view full answer...

What Size Hole Saw to Install Epicord Batt Disconnect #277-000096

Product Page this Question was Asked From

Continue Researching