Does Tekonsha Wiring Harness 118426 Fit 2007 Ford Escape Hybrid Without Factory Tow Package
Question:
part # 118426. Will this part work on a 2007 Ford Escape Hybrid with no factory hitch package, and is set up to tow 4 flat using diodes mounted before the factory taillight fittings?
asked by: Mark D
0
Expert Reply:
Yes, the T-One Vehicle Wiring Harness # 118426 will absolutely fit your 2007 Ford Escape hybrid that does not have the factory tow package.
The diodes that are installed on your Escape for flat towing will not affect the wiring harness or interfere with its effectiveness. I have added a link below to a video install on an '07 Escape for you to check out as well of the T-One Vehicle Wiring Harness # 118426.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Choosing Between Tekonsha or Curt Powered Taillight Converter/Wiring Harness for 2020 Honda Odyssey
- Q&A: Trailer Turn Signals Both Blink at the Same Time When Right or Left Turn Signal is Turned On
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Q&A: What Causes Trailer Wiring Harnesses to Short Out
- Q&A: Trailer Lights on When 2003 Ford Windstar Lights are Off
- Q&A: Can a Taillight Converter Module Go Bad After Working Properly for Months
- Q&A: Replacement Tank for GC6AA-8 SPK Atwood Water Heater
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Ball Mount Basics: Weight Capacity, Class, and Size