Where is the Brake Controller Adapter Plug on a 2006 Dodge Durango
Question:
Where do you plug in a brake controller adapter harness in a 2006 Dodge Durango. Cannot locate a port under the dash.
asked by: Dale B
Expert Reply:
If your 2006 Dodge Durango came with the 7 way plug from the factory, the plug for the brake controller adapter should be up along the kick plate near the emergency brake. If your Durango did not come from the factory with a 7 way plug, that port is not going to be present and you wouldn't be able to use the # 3020-P to install a brake controller.
If you don't have the port to plug into, you'll instead need to use the # 20127 and hardwire in the connection. I've linked a video of a hard wire installation on a Durango, as well as a video that shows where the port is on a Dodge Ram truck that will help give you a better idea of what to look for.
Products Referenced in This Question
Replacement Brake Control Plug-In Harness for Tekonsha and Draw-Tite Brake Controller 12" Long
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Universal
- Draw-Tite
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dodge
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Brake Controller Recommendation for a 2006 Dodge Ram 2500
- Article: Troubleshooting Brake Controller Installations
- Q&A: Actual Measured Dimensions of Ventline Exterior Wall Vent for RV Range Hood V2111-03
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Battery Charger for a Trailer Battery on a Dump Trailer
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Q&A: Grease Seal Fit based on Inner Diameter and Outer Diameter