Dimensions of the Pipe Mount for the Bulldog Trailer Jack with 5,000 lb Capacity
Question:
Male mount that is welded on the swivel Jack. What are the demensions? ID= OD= Thanks
asked by: Steven K
0
Expert Reply:
I went out into our warehouse and measured the inner and outer diameter of the mounting bracket that is on the Bulldog Round, Pipe-Mount Swivel Jack # BD178101 and found that the outer diameter measures 2 inches and the inner diameter measures 1-1/2 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Round, Pipe-Mount Swivel Jack - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Replacement Axle for Quality Trailer Products Model TS70
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Comparing Trailer Breakaway Switch Kits
- Q&A: Can I Guess or Estimate Axle Weight Capacity By Number of Lug Nuts
- Article: How to Mount a Truck Bed Camper
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Q&A: Replacement Tire Recommendation for a 18.5x8.5x8 Tire Size