2008 Range Rover Brake Controller Recommendation
Question:
2008 Range Rover hse factory tow harness with 4 and 7 pin. Do I need a brake controller if pulling a 5k pound travel trailer? And if I do what will be the best
asked by: Khoa
Expert Reply:
Anytime the weight of the trailer is over half the weight of the towed vehicle it's strongly recommended you install a brake controller. In the event you need to make an emergency stop a brake controller makes a huge difference.
Since you have a 7-way installed already the easiest solution is the Curt Echo Mobile part # C51180. Basically this just plugs into an active 7-way and once synced to your smart phone is ready to tow. No lengthy install or complicated wiring at all! I attached a review video for more info as well.
Product Page this Question was Asked From
Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Trailer Brake Controller
- Proportional Controller
- Hidden
- Up to 2 Axles
- Smartphone Display
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Curt Echo Full Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Solution for Suspension Sag on 2016 Toyota Highlander Towing Trailer
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?